Drape Receiver for venetians programming and installation

Single Control

• Set the Centralis indoor RTS in its programming mode by pressing the PROG button until the LED lights (approx. 2 seconds).
  This indicates that the CENTRALIS indoor RTS is ready to receive the address of a CENTRALIS RTS for one minute.
• Press shortly the programming button on the CENTRALIS RTS
  - The LED of the CENTRALIS indoor RTS blinds indicating that the address of the CENTALIS RTS is memorized in the CENTRALIS indoor RTS which automatically quits its programming mode.

Multiple Control

• Assign several RTS controls to the CENTRALIS indoor RTS following the same procedure as described above. You can assign up to 16 controls to one receiver. If you try to enter 17 your instructions will be ignored , the LED of the receiver will go out.

General or Group Control

• Set all the CENTRALIS indoor RTS that you wish to control by one CENTRALIS RTS in their programming mode.
• Press shortly the programming button of the CENTRALIS RTS
  - The LEDs of all the CENTRALIS indoor RTS blind indicating that the address of the CENTRALIS RTS has been memorized in all these receivers.

• Press more than 2 seconds on the programming button of a CENTRALIS RTS which is already memorized in the CENTRALIS indoor RTS in order to 'wake up' the CENTRALIS indoor RTS.
  - The LED of the CENTRALIS RTS lights on, indicating that all the CENTRALIS indoor RTS which have the address of this CENTALIS RTS are in their programming mode for one minute.
• Press shortly the programming button of the new CENTALIS RTS you wish to assign.
  - The address of the Centralis RTS is memorized in all the CENTRALIS indoor RTS which automatically quit their programming mode.

To remove a CENTRALIS RTS from the memory of a CENTRALIS indoor RTS , set the CENTARLIS indoor RTS in its programming mode , then press shortly the prog button on the CENTRATLIS RTS you wish to remove

It is also possible to 'wake up' the CENTRALIS indoor RTS with another CENTRALIS RTS , then press shortly the prog button of the CENTRALIS RTS you wish to remove.

To remove the addresses of all the CENTRALIS RTS from the memory of a CENTRALIS indoor RTS , press the programming button of the CENTRALIS indoor RTS until the LED blinks
- The memory of the receiver is erased.

• Set the CENTRALIS indoor RTS in its programming mode by pressing the PROG button until the LED lights (approx. 2 seconds)
  This indicates that the CENTRALIS indoor RTS is ready to receive the address of an INIS RT for one minute.
• Remove and replace the battery of the INIS RTS , then Press shortly the push button on the INIS RT
  - The LED of the CENTRALIS indoor RTS blinks, indicating that the address of the INIS RT is memorized in the CENTRALIS indoor RTS which automatically quits its programming mode.

To Remove the addresses of the INIS RT from the memory of a CENTRALIS indoor RTS, press the programming button of the CENTRALIS RTS until the LED blinks (approx. 10 seconds)
- The memory of the receiver is erased.