Centrallis wall switch programming and installation

Single Control

• Set the RTS receiver in its programming mode (refer to the installation guide for the concerned RTS receiver)
• Press shortly the programming button on the backside of the centralis rts
  - The RTS receiver emits a signal (LED or Buzzer depending on the type of receiver) indicating that the address of the CENTRALIS RTS has been memorized in the RTS receiver.

Multiple Controls

• Assign several CENTRALIS RTS to a RTS receiver following the same procedure as described above
  You can assign up to 16 CENTRALIS RTS to one receiver. If you try to enter a 17th, your instruction will be ignored, the led of the receiver will go out

General or Group Control

• Set all the RTS receivers you wish to control by one CENTRALIS RTS in their programming mode
• Press Shortly the programming button on the backside of the CENTRALIS RTS in their programming mode.
  - The RTS receivers emits a signal (LED or Buzzer depending on the type of receiver) indicating that the address of the CENTRALIS RTS is memorized in all these receivers.

• Press more than two seconds on the programming button on a CENTRALIS RTS which is already memorized in the RTS receiver in order to "wake up" the receiver
  - The LED of the CENTRALIS RTS lights on, indicating that all the RTS receivers which has the address of the CENTRALIS RTS are in their programming mode for one minute
   
• Press shortly the programming button of the new CENTRALIS RTS you wish to assign.
  - The address of the CENTRALIS RTS is memorized in all the RTS receivers which automatically quit their programming mode

To remove a CENTRALIS RTS from the memory of a RTS receiver, set the RTS receiver in programming mode, then press shortly the prog button of the Centralis RTS you wish to remove.

It is also possible to "wake up" the receiver with another CENTRALIS RTS, then press shortly the prog button on the Centralis RTS you wish to remove